WingTite Instructions

pdf download Click here to download PDF
See how it works, click to watch the video

Click here to download PDF

Recommended Tools and Materials

tools tools tools

We Sell Adapters for the Pipe Sizes Below. To Order Call 800-200-2678.

adapter
Inside Bushing
for 2” ABS / PVC
adapter
1-1/2”
Galvanized
adapter
1-1/2”
Copper
adapter
2”
Copper

Removing Drain Seal - 2 Part System (Threaded Nut & Gasket Type)


removing drain seal: step 1

1
Remove the Drain cover with flat blade screwdriver.
removing drain seal: step 2
2
Extract the compression gasket assembly exposing 2” pipe riser and drain body by unthreading compression nut and pulling gasket out with needle nose pliers.

Removing Drain Seal - 3 Part System (AB&A Sure Fit)




removing drain body: step 1

1
Remove the Drain cover with flat blade screwdriver.
removing drain body: step 2
2
Insert drywall screws into opposite sides of ring-gasket and split ring removing one at a time exposing 2” pipe riser & drain body.

Removal of Drain Body

removing drain body: step 3
3
With hacksaw, make two vertical cuts approximately 1” apart through drain body. Cut completely through drain body without cutting into shower pan or scoring pipe riser.
removing drain body: step 4
4
Continue cutting horizontally through drain flange to weaken it, but not deep enough to damage pan.
removing drain body: step 5
5
Once horizontal flange is cut, use flat blade screwdriver to pry on 1” flange to break free from shower pan.
removing drain body: step 6
6
Remove 1” width of the drain body from pan.
removing drain body: step 7
7
Squeeze the shower drain to collapse it, this allows the retaining nut below shower base to drop. Nut stays below.
removing drain body: step 8
8
Remove shower drain from pan. Clean shower surface around drain hole, above and below the pan to insure proper seal and unrestricted wing movement.

WingTite Installation

installation: step 9
9
Remove WingTite from package. Installation is ready to begin.
installation: step 10
10
Apply liquid dish soap to drain O-ring as lubricant.
installation: step 11
11
Apply a generous amount of 100% silicone to underside of WingTite drain flange.
installation: step 12
12
The four fastening wings must be against drain body at time of insertion into shower pan.
installation: step 13
13
Insert drain into shower pan and press evenly over 2” drain pipe. Once drain has made contact with shower pan, hold firmly in place. Inspect pipe riser to ensure full contact with O-ring seal.
installation: step 14
14
Tighten all four Phillips head wing screws evenly until drain is secure in pan. 20 Inch pounds maximum!

* DO NOT TIGHTEN PHILLIPS HEAD WING SCREWS WITH POWER TOOLS !!!
installation: step 15
15
Clean excess silicone from drain and pan with rag. Test the shower drain and install cover.

WingTite Technical Support: 805-927-1753.
Available Weekdays 10 A.M. - 4 P.M. (PST).